Traces and traffic dump

The association is not OK without traces and dump.

Re-Question

1. We are in relation with Schneider electric and Schneider electric is using the TI ZStack for their developments.

So the main target is to be communicate with ZSTack coordinator.

I accept with pleasure your proposition to send me some tests with TI ZStack.

This is my e-mail: yteissier@assystem.com

2. In fact the coordinator was with ZBOSS. I'm working on...

Regards,

Yves

Does it mean that association is OK without trace/dump?

And about your questions:

1. Yes, we did it. As well as we have a dozen of different interoperability tests.

2. IAR is a great tool, so, you could check ZStack stack usage for idle stack, and if it's above 80% - the simpliest way is to increase it. Or you can try to

find the reason of such behavior by analyzing your ZStack application and ZStack settings as well. I'm not sure about latest ZStack, but previously we had to add some tuning to ZStack (but I think you've done it already, because you can join). I can provide some of these tests to you, if you're interested in interoperability with TI.

Yes the association is OK and I can send messages to the coordinator when

traces and dump are enabled.

I have also another question:

-Have you try to join a ZBOSS End device a TI ZStack coordinator ?

-The End Device send with success message to the coordinator but after the third message sent the coordinator seems

to by crashed... In debug mode I have seen a message "XStack is filled at 100%".

Regards,

Yves

Hi Yves,

Yes, it's possilbe to disable both traffic dump and trace messages. But as far as I remember, we didn't test this configuration with TI Chips.

Is association passed normally with these settings?

B.R.

Denis